Skoda Roomster Owner's Manual page 76

Dividing up the luggage compartment with variable loading floor

Read and observe on page 73 first.
›
Lift up the part with the holder and secure it by sliding it into the grooves
marked with the arrows » Fig. 66.
Removing and refitting the variable loading floor
Fig. 67 Fold up variable loading floor/remove

Read and observe on page 73 first.
Removing
›
Unhook the loops » Fig. 67 of the elastic partition from the fixing points.
A
›
Unlock the variable loading floor by turning the locking bolts
around 180°.
›
Fold up the variable loading floor by moving it in the direction of the arrow
.
C
›
Fold up the variable loading floor in the direction of the arrow
by pulling in the direction of the arrow
74
Operation
Fig. 66
Dividing the boot
to the left by
B
and remove
1
.
2
Fitting
›
Fold up the variable loading floor and place it on the carrier rails.
›
Fold out the variable loading floor.
›
Lock the variable loading floor by turning the locking bolts
right through around 180°.
›
Secure the loops of the elastic partition to the fixing points.
A
WARNING
Ensure that the carrier rails and variable loading floor are correctly fastened
when installing the variable loading floor. If this is not the case, there is a
risk of injury for the occupants.
Removing/installing the carrier rails
Fig. 68 Boot: Slacken check points/remove carrier rails

Read and observe on page 73 first.
Removing
›
Undo the securing points » Fig. 68
B
key or a flat screwdriver.
›
Remove the carrier rail and remove by pulling in the direction of arrow
A
The carrier rail on the other side of the luggage compartment can be re-
moved in the same way.
Fitting
›
Position the carrier rails on the sides of the boot.
›
Press the securing point » Fig. 68
B
›
Check the attachment of the carrier rails by pulling it.
» Fig. 67
B
on the carrier rails using the vehicle
on each carrier rail to the stop.
to the
.
1
