Start-Stop - Skoda Roomster Owner's Manual

›
The speed will decrease continuously, if the rocker button is pressed and
held in the SET position. Release the rocker button once the desired speed is
reached. The set speed is then stored in the memory.
›
If the rocker button is released at a speed below around 25 km/h, the speed
is not stored and the memory is erased. The speed must then be stored
again by pressing rocker button
speed of the vehicle to more than around 25 km/h.
The speed can also be reduced by depressing the brake pedal, which tempora-
rily deactivates the system.
Switching off temporarily

Read and observe and
The cruise control system can be temporarily switched off by pushing switch
» Fig. 117 on page 119 to the spring-loaded CANCEL position or by depress-
A
ing the brake or clutch pedal.
The set speed remains stored in the memory.
Briefly push rocker button to the RES position to resume the set speed af-
B
ter the clutch or brake pedal is released.
Switching off completely

Read and observe and
›
Press switch » Fig. 117 on page 119 to the right to the OFF position.
A

START-STOP


Introduction
This chapter contains information on the following subjects:
Operating conditions for the system
Operation
System related automatic start-up
Manually deactivating/activating the system
Information messages
120
Driving
to the SET position after increasing the
B
on page 119 first.
on page 119 first.
The START-STOP system (hereinafter referred to as the system) saves fuel and
reduces polluting emissions and CO
when stopping at traffic lights, and starting the engine again when moving off.
WARNING
Never let the vehicle roll with the engine switched off.
■
The brake servo unit and power steering only operate if the engine is run-
■
ning.
Operating conditions for the system

Read and observe
For system-dependent automatic engine shutdown to work, the following
conditions must be met.
The driver's door is closed.

The driver has fastened the seat belt.

The bonnet is closed.

The driving speed exceeded 4 km/h after the last stop.

No trailer is coupled.

Some additional conditions for the system to function correctly cannot be in-
fluenced or recognised by the driver. Therefore, the system can react differ-
120
ently in situations which are identical from the driver's perspective.
121
If after stopping the car, the message UNABLE TO START STOP appears in the
121
segment display or the 
121
play, then the conditions for automatic engine shutdown are not met.
121
emissions by turning the engine off, e.g.
2
Fig. 118
Maxi DOT display: Engine is auto-
matically switched off / automat-
ic engine cut off is not possible
on page 120 first.
» Fig. 118 check mark appears in the MAXI DOT dis-
