Configure Call Routes On Ucm6100; Figure 6: Configure Outbound Route On Freepbx - Grandstream Networks UCM6100 Series Configuration

trunk.
2. The FreePBX uses DID for inbound route by default. Therefore the extensions on the UCM6100 can
directly reach the extensions on the FreePBX. There is no additional configuration required for
inbound route as a basic configuration sample.

Configure Call Routes on UCM6100

1. On the UCM6100 web GUI, go to PBX->Basic/Call Routes->Outbound Routes to create a new
outbound rule. This would allow the extension on the UCM6100 to reach extensions (5xx, in this
example) on the FreePBX.
Firmware Version 1.0.1.25

Figure 6: Configure Outbound Route on FreePBX

Configuring UCM6100 Series With FreePBX Page 8 of 10