Assembly; Assembling And Aligning The Table Extension; Attaching Dust Elbow And Dust Bag - RIDGID MS1250 Owner's Manual

Assembly

WARNING: For your own safety,
never connect plug to power
source outlet until all assembly
steps are complete, and you
have read and understood the
safety and operational instruc-
tions.
Assembling and Aligning the Table
Extension
1. Locate the table extension. Locate the
bag assembly with the two cap screws
and two washers.
1. Place the two bolts and washers
through the holes in the table extension
and fasten onto the end of the table.
Finger tighten only.
2. Use a straight edge to align the table
extension to both the fence and base of
the saw as shown.
3. Using the 1/4" hex end of combination
wrench securely tighten the two cap
screws.
Attaching Dust Elbow and Dust
Bag
Place the dust elbow into the 2-1/2 inch
dust port at the rear of the saw.
To attach the dust bag squeeze the spring
clamp on the bag and place it over the
dust elbow.
If desired a 2-1/2 inch wet/dry vac hose
may be inserted into the dust port or into
the elbow.
If desired, the dust bag may be attached
directly to dust port on saw.
WARNING: To reduce the risk of
injury from thrown sawdust and
wood chips, never operate saw
without dust bag, dust elbow, or
vac hose installed. Always direct
elbow away from bystanders and
operator.
Lock Pin
Cap Screws
12
Table Extension
Washer
Straightedge