Installation On The Floor - Pioneer PDP-V402 Technical Manual

Special installation (Installation on the floor)

3.4.10 Installation on the floor

This display is designed to accommodate floor installation, but certain specific installations may interfere with adequate
ventilation. Always observe the following conditions:
1 Use plate metal that keeps all single holes clear and has dimensions no larger than those given in the following
table.
2 Leave adequate ventilation space between the display and the floor.
3 Use plate metal having sufficient strength, and attach at the four points indicated in the following drawing (four-
point mounting).
4 Recommended ambient operating temperatures are listed in the following table. Operate the display within this
temperature range.
5 The ceiling should closely approximate a perfectly flat plane. Keep deformation pressures upon the display, such
as twisting and bending, at or below 1 mm.
50mm
50mm
Floor
Working temperature requirements
A size
50 mm or more
* The same conditions apply to the working temperature requirements for a speaker system (PDP-S03-LR).
* When mounting the down converter (PDA-4003), the same working temperature conditions apply.
52
Do not block this area at the top or bottom.
75mm 75mm
694 mm (center indicated)
VIDEO
0~40°C
75mm 75mm
PC-9800 (56.4Hz)
PC-9800 (70.1Hz)
Machintosh (66.7Hz)
VGA (72.8Hz, 75Hz)
VGA (60Hz)
0~40°C 0~35°C
Floor
Floor
A