Pioneer PDP-V402 Technical Manual page 74

How to mount
Align each rivet hole of the plasma display with a matching
mounting hole of this device while pressing the device
with your left hand. Mount the device using the attached
screw rivets in order of 1, 2, 3 and 4 as shown in the
figure below.
Just inserting the screw rivets into the holes and pushing
them down into the holes by hand can securely mount
the device.
How to attach screw rivets
Inserting the screw rivets and pushing down the screw
portion from above can secure the screw rivets.
How to remove the screw rivets
As the screw rivet head is cross-sloted, use a Phillips
screwdriver to remove the screw rivet. The remaining part
of a screw rivet will come off, when this device is pulled
up with the screw portion removed.
How to mount standard optional items (PDA-4003)
1
4
2
3
How to mount AC adapter
When mounting AC adapter, use the attached hook and
loop fasteners.
Attach one portion of the hook and loop fastener to the
AC adapter (on the side on which the caution label is not
attached) and the other portion on the backside of the
plasma display in order to mount the AC adapter.
Horizontal direction
Attach it between this device and the fan.
NOTICE:
• When attaching the hook and loop fastener to
the AC adapter as well as this device, make sure
to remove dirt and dust before attaching it.
Vertical direction
Attach the hook and loop
fastener so that the bottom
of the AC adapter will be
located at the center of
lowermost fan in height.
Route the cord though
the cable clamp, avoiding
the fan hole.
73