Pioneer PDP-V402 Technical Manual page 133

How to mount standard optional items (PDM-4001)
4) Mounting a plasma display
1. Remove hole rivets (at four points as shown by an arrow) from the backside of the display using a coin, etc.
2. Insert the attached monitor securing bolts into multiple installation fixtures at the points as shown in the above
drawing of a plasma display.
3. Release the locking fittings, and pull out the slide frame (See the next page on how to release them).
4. Insert the monitor securing bolts into potbellied holes located on the front side of the plasma display.
132
Bolts for secur-
ing the monitor
When placing the nuts, ensure that the end of a nut
and a thread are aligned on the same surface.
Caution
When returning the pulled-out frame,
be careful not to pinch your fingers.
Hole rivet