Before making adjustments
5.1 Before Beginning Adjustments
You can make adjustments to the unit in the following ways:
• With the operating panel of the main unit
• With the remote control unit
• With a PC (through RS-232C control)
Make sure you've thoroughly read and understood the following before making any adjustments.
5.1.1 Operating mode
The unit has the following four major operating modes:
2 Menu Mode
SCART RGB (Note:6)
Note 1: Only when VIDEO and Y/C are input.
Note 2: Only when RGB1 and RGB2 are input.
Note 3: Only indication
Note 4: Only when NTSC signal, no signal, or no applicable signal is input (VGA, Macintosh, PC-9800 inputs).
Cannot adjust when PAL signals are input <PAL signals can be input only for PDP-V402E>.
Note 5: Only when signals other than the NTSC signal are input.
Note 6: PDP-V402 only
1 Normal Operating Mode
3 Integrator Mode
ADDITIONAL SET UP
MP MODE (Note:5)
NTSC MASK (Note:4)
FOUR METER (Note:3)
> indicates RS-232C command op-
4 RS-232C Adjustment Mode
See the description provided in
"5.3 Outer control by RS-232C".
indicates operating mode and
indicates button operations on
the remote or on the main unit's