Getting Started; Assembling Your Vacuum Cleaner - Vax Power U84-M1-Be Let's Get Started

PLEASE READ 'LET'S TALK SAFETY' AT THE BEGINNING BEFORE USE
Before you begin
WARNING: Always switch off the vacuum cleaner before connecting or disconnecting the hose/attachments
or removing and emptying the dirt container.
IMPORTANT: The vacuum cleaner is equipped with a thermal cut-out. If for any reason the vacuum cleaner does
overheat the thermostat will automatically turn the vacuum cleaner off . If this happens switch the vacuum cleaner off
and unplug from electrical socket. Remove and empty the dirt container also check the vacuum cleaner for blockages.
Allow the vacuum cleaner to cool for approximately 1 hour (if you have cleaned the fi lters please wait 24 hours for the
fi lters to fully dry before putting back into the machine).
For best cleaning results, fi lters should be tapped over a bin every 4-6 uses to remove dirt and debris and washed every
3 to 6 months (depending on the level of use).
If the vacuum cleaner is blocked, switch off and unplug before removing the blockage.
When the vacuum cleaner is stood in the upright position, or when using the hose and tools the brushbar height adjuster
must be set to the highest setting.

Assembling your vacuum cleaner

Press the release clip on
the stretch hose, line up
and push the hose into
the handle.
Slide the handle down
into the main body of
the vacuum cleaner.

Getting started

Line up the stretch hose with hose
guides, push and clip stretch hose
into place. The end of the stretch
hose will hang loose at the bottom
of the machine