Taking Care Of Your Machine - Vax Power U84-M1-Be Let's Get Started

IMPORTANT: The motor is equipped with a thermal cut-out. If for any reason the machine should overheat, the
thermostat will automatically turn the machine off . Switch off and unplug the vacuum cleaner. Check the machine for
blockages and clean the fi lters . Wash the fi lters with warm water (40°C max) and leave for 24 hours or until fully dry
before replacing into the machine.
For best cleaning results, fi lters should be tapped over a bin every 4-6 uses to remove dirt and debris and washed
every 3 to 6 months (depending on the level of use).
Don't use your vacuum cleaner without all of the fi lters in place.
Emptying the dirt container
Press the dirt container
release button, pull and
remove the dirt container.
Don't over fi ll the dirt container to avoid blocking the air fl ow through the vacuum cleaner and replace fi lters
every 6-9 months.
Cleaning the pre-motor fi lter
Turn the dirt container
lid anti-clock wise , lift
and remove the lid
from dirt container.

Taking care of your machine

Hold the dirt container
over a bin.
Pull the fi lter tab and
remove the pre-motor fi lter.
Press the dirt release clip,
allowing dirt/debris to fall out.
Tap the fi lter over a bin
to remove any dirt/debris.
Wash the fi lter under running
water (40°C max).
24hr
24hr
Leave for 24hrs or until
fully dry before replacing.