Getting Started - Vax TBT3V1T1 Manual

PLEASE READ 'LET'S TALK SAFETY' AT THE BEGINNING BEFORE USE
Before you begin
CAUTION: Always switch off the slim vac before connecting or disconnecting the handheld/attachments or
removing and emptying the dirt container.
IMPORTANT: The slim vac is equipped with a thermal cut-out. If for any reason the slim vac does overheat, the
thermostat will automatically turn the slim vac off. If this happens empty the dirt container and check the slim vac
for blockages. Allow the slim vac to cool for approximately 1 hour (if you have cleaned the filter, wait 24 hours for
the filter to fully dry before putting back into the machine).
For best cleaning results, filters should be tapped over a bin every 4-6 uses to remove dirt and debris, and
washed every 3 months depending on the level of use.
Assembling your cordless slim vac
CAUTION: This slim vac is not free standing. Between uses or when carrying out any maintenance,
always lie flat on the floor in a suitable location so that it does not become a trip hazard or can be stepped on.
Line up the connector on
the reach wand with the
Powered Head. Push the
reach wand down onto
the Powered Head until it
clicks into place.
Push the handheld down
onto the reach wand until
it clicks into place.

Getting started

The slim vac is not free standing and between uses
must always be placed in the wall bracket or laid flat
on the floor in a suitable location, so that it does not
become a trip hazard or can be stepped on.