Getting Started - Vax Air Lift 2 User Manual

PLEASE READ THE SAFETY GUIDE BEFORE USE.
IMPORTANT: Always switch off and unplug the machine before performing maintenance or
troubleshooting checks. Switch the machine off before connecting or disconnecting the lift-out, hose
and accessories or before emptying the dirt container.
The motor is equipped with a thermal cut-out. If for any reason the machine should overheat, the
thermostat will automatically turn the machine off. If this happens unplug the machine and remove
and empty the dirt container. Check the machine for blockages and clean the filters if required.
Allow the machine to cool for approximately 1 hour. If you have washed the pre-motor filter, wait 24
hours or until fully dry before putting it back into the machine.
For best cleaning results, filters should be tapped over a bin every 4-6 uses to remove dirt and debris,
washed every 3 months (depending on the level of use) and replaced every 9-12 months.
Assembly
Slide the handle with the
extension wand into the
top of the machine until it
clicks into place.
Push the 2-in-1 tool onto
the storage clip.

Getting started

5