Install The Light; Attach Manual Release Handle - Chamberlain ATS 211 Owner's Manual

Installation Step 7

Install the Light

Install the Light
• Install a 75 watt maximum light bulb in the socket.
The light will turn ON and remain lit for
approximately 4-1/2 minutes when power is
connected. Then the light will turn OFF.
• If the bulb burns out prematurely due to vibration,
replace with a "Garage Door Opener" bulb.
Installation Step 8
Attach the Manual Release
Rope and Handle
Trolley
Rope
Overhand
Knot
Do not use the red handle to pull the door
open or closed. The rope knot could become
untied and you could fall. Use the manual
release only to disengage the trolley and, if
possible, only when the door is closed.
If the door is open when the handle is pulled,
the door could close inadvertently if it is not
properly balanced.
• Thread one end of the rope through the hole in the
top of the red handle so "NOTICE" reads right side
Overhand
up as shown. Secure with an overhand knot.
Knot
The knot should be at least 1" from the end of the
rope to prevent slipping.
Trolley
• Thread the other end of the rope through the hole in
Release Arm
the release arm of the outer trolley.
• Adjust rope length so the handle is 6 feet above the
floor. Secure with an overhand knot.
Manual
Release Handle
If it is necessary to cut the rope, heat seal the cut
end with a match or lighter to prevent unraveling.
14
75 Watt Max.
Light Bulb
WARNING
Opener