Table of Contents
Advertisement
Installation
IMPORTANT INSTALLATION INSTRUCTIONS
To reduce the risk of SEVERE INJURY or DEATH:
•
This portable luminaire has a polarized plug (one blade
is wider than the other) as a feature to reduce the risk of
electric shock.
•
This plug will fit in a polarized outlet ONLY one way. If the
plug does not fit fully in the outlet, reverse the plug. If it still
does not fit, contact a qualified electrician.
6
Install myQ Remote
LED Light
The myQ Remote LED Light is designed to
plug directly into a standard 120V outlet.
Select an appropriate location on the
ceiling or wall to mount the light within 6
feet (1.83 m) of an electrical outlet so that
the cord and light are away from moving
parts.
NOTE: If installing light on drywall and a
ceiling joist cannot be located, use drywall
anchors provided. No pilot hole is required
for drywall anchors.
1.
Drill pilot holes 6-1/8" (15.6 cm) apart
if mounting to joist.
OR
Screw in drywall anchors 6-1/8"
(15.6 cm) apart if mounting to
drywall.
2.
Determine the length of power cord
needed to reach the nearest outlet.
Wind any excess cord around cord
retainer on the top side of the light
base. Route the cord through the
channel so the light mounts flush.
3.
Open the light lens.
4.
Mount the light with the screws
provided.
5.
Close the light lens.
6.
Plug in the light to the outlet.
NOTE: The LED light is very bright.
DO NOT stare at the light while on a
ladder.
Your garage door opener remote light has
already been programmed at the factory to
operate with your opener. Any additional or
replacement remote lights will need to be
programmed.
•. DO NOT alter the plug.
•. Light is intended for ceiling or wall mount and indoor
applications ONLY.
HARDWARE
Drywall Anchor (screw-in) (2)
Cord Retainer
Channel
Light Lens
13
Screw #6x1" (2)
6-1/8" (15.6 cm)
Drywall
Anchors
Screws
Advertisement
Table of Contents
