Adjusting The Input Elevator - Kodak i4250 User Manual

Hide thumbs Also See for i4250:
Table of Contents

Advertisement

A-61837 June 2015
• Adjusting the height of the input elevator — the input elevator can be set
to accommodate stacks of 25-, 100-, 250- or 500-documents of
2
20 lb. /80 g/m
bond paper. Input elevator settings are typically made
through your scanning application software (e.g., TWAIN Datasource or ISIS
Driver).
The input elevator setting can be overridden by using the Operator Control
Panel. For more information see the section entitled, "Application
Overrides" later in this chapter.
When the input elevator is set to the Document Feeder position, the input
elevator will remain in the highest position. When set to 100, 250 or 500,
the input elevator will automatically raise to feed documents and lower
after the last document in your stack has been fed.

• Adjusting the input elevator

- Document lengths up to 27.9 cm (11 inches) — no adjustments are
required.
- Document lengths from 27.9 to 43.2 cm (11 to 17 inches) — pull out
the document extender.
- Documents lengths more than 43.2 cm (17 inches) — if you are
scanning documents longer than 43.2 cm (17 inches), the scanner driver
must be set to accommodate these long documents. Be sure to verify that
the Maximum Length option on the Device-General tab (TWAIN
Datasource) or the Longest Document option on the Scanner tab (ISIS
Driver) is set to longer than the longest document being scanned.
NOTES:
• Operator assistance may be required for scanning documents greater
than 43.2 cm (17 inches).
• It is recommended that you use a document extender if you are
scanning documents longer than 43.2 cm (17 inches). Three sizes of
document extenders are available for scanning documents from
43.2 cm (17 inches) to 86.36 cm (34 inches). See the section entitled,
"Supplies and Consumables" in Chapter 5.
• Document weights — the maximum document weight for the input
elevator is the approximate weight of an A3 (11 x 17-inch) 500-sheet
ream of paper. If you are scanning documents larger than A3
(11 x 17-inch), the recommended weight capacity should not exceed
4.5 kg (10 pounds). If the documents you are scanning are larger than A3
(11 x 17-inch), scan less than 100 sheets at a time.
3-3

Hide quick links:

Advertisement

Table of Contents
loading

This manual is also suitable for:

I4850I4650

Table of Contents