Adjusting The Input Elevator - Kodak i5000 series User Manual

A-61670 December 2010
• Adjusting the height of the input elevator — the input elevator can be set
to accommodate stacks of 25 or less (ADF mode) 100-, 250-, 500- or 750-
documents of 20 lb./75 g/m
through your scanning application software (i.e., TWAIN Datasource or ISIS
Driver).
When the input elevator is set to ADF mode (25 documents or less), the
input elevator will remain in the up position. When set to 100, 250, 500 or
750 the input elevator will automatically raise to feed documents and lower
after the last document in your stack has been fed.

• Adjusting the input elevator

- Document lengths up to 35.6 cm (14 inches) — no adjustments are
required.
- Document lengths from 35.6 to 43.2 cm (14 to 17 inches) — slowly pull
out the document extender.
- To push the extender back into place, position your fingers on the sides of
the extender (at the arrows on the extender) and slide the extender back
into place.
- Documents lengths more than 43.2 cm (17 inches) — if you are
scanning documents longer than 43.2 cm (17 inches), the scanning
application must be set to accommodate these long documents. Be sure
to verify that the Maximum Length option on the Device-General tab
(TWAIN Datasource) or the Longest Document option on the Scanner
tab (ISIS Driver) is set to longer than the longest document being
scanned.
NOTES:
• Operator assistance may be required for scanning documents greater
than 43.2 cm (17 inches).
• It is recommended that you use a document extender if you are
scanning documents longer than 43.2 cm (17 inches). Three sizes of
document extenders are available for scanning documents from
43.2 cm (17 inches) to 86.36 cm (34 inches). See the section entitled,
"Supplies and Consumables" in Chapter 5 for ordering information.
• Document weights — the maximum document weight for the input
elevator is the approximate weight of a 500-sheet ream of A3 (11 x 17-
inch) paper or a 750-sheet ream of A4 (8.5 x 11) paper. If you are
scanning documents larger than A3 (11 x 17-inch), the recommended
weight capacity should not exceed 4.5 kg (10 pounds). If the documents
you are scanning are larger than A3 (11 x 17-inch), scan less than 100
sheets at a time.
2
bond paper. Input elevator settings are made
3-3