Adjusting The Input Elevator - Kodak i4000 Plus Series User Manual

A-61651 August 2013
• Adjusting the height of the input elevator — the input elevator can be set
to accommodate stacks of 25-, 100-, 250- or 500-documents of
2
20 lb./80 g/m bond paper. Input elevator settings are made through your
scanning application software (i.e., TWAIN Datasource or ISIS Driver).
When the input elevator is set to 25, the input elevator will remain in the up
position. When set to 100, 250 or 500, the input elevator will automatically
raise to feed documents and lower after the last document in your stack has
been fed.

• Adjusting the input elevator

- Document lengths up to 35.6 cm (14 inches) — no adjustments are
required.
- Document lengths from 35.6 to 43.2 cm (14 to 17 inches) — pull out
the document extender.
- Documents lengths more than 43.2 cm (17 inches) — if you are
scanning documents longer than 43.2 cm (17 inches), the scanner driver
must be set to accommodate these long documents. Be sure to verify that
the Maximum Length option on the Device-General tab (TWAIN
Datasource) or the Longest Document option on the Scanner tab (ISIS
Driver) is set to longer than the longest document being scanned.
NOTES:
• Operator assistance may be required for scanning documents greater
than 43.2 cm (17 inches).
• It is recommended that you use a document extender if you are
scanning documents longer than 43.2 cm (17 inches). Three sizes of
document extenders are available for scanning documents from
43.2 cm (17 inches) to 86.36 cm (34 inches). See the section entitled,
"Supplies and Consumables" in Chapter 5.
• Document weights — the maximum document weight for the input
elevator is the approximate weight of an A3 (11 x 17-inch) 500-sheet
ream of paper. If you are scanning documents larger than A3
(11 x 17-inch), the recommended weight capacity should not exceed
4.5 kg (10 pounds). If the documents you are scanning are larger than A3
(11 x 17-inch), scan less than 100 sheets at a time.
3-3