Table of Contents
Advertisement
Ready to move on? Well alrighty!
1. If you're using an external wireless DMX transmitter like our wiCICLE® transmitter or
LightCaster® transceiver, plug it into the "DMX OUT" connector of the controller and verify it
is receiving power. If you are using a DMX controller with a built-in DMX transmitter like our
KONTROL 5 SKYWIRE™, enable the DMX transmitter on that unit. Please refer to your transmitters
user manual for specific instructions on enabling wireless DMX output and/or its changing its
channel group selection.
2. Set the wireless channel group to match the transmitter group ID number/color code.
a.) Press the <MENU> button until the display reads RF-ID. (See p. 12-13)
b.) Use the <UP/DOWN> buttons to select number 1-7.
c.) Press <ENTER> to confirm the setting.
Note: The 7-Color Status LED will change color to indicate the current channel group:
· GROUP 1:
· GROUP 2:
· GROUP 3:
· GROUP 4:
· GROUP 5:
· GROUP 6:
· GROUP 7: WHITE
3. The LED on the transmitter will blink
receiver. The status LED on the receiving fixtures will flash
is established.
4. Once the clearest channel is auto-selected, the status LEDs will blink quickly on both the
transmitter and receiver. NOTE: The color of the SkyBox Chroma's status LED DURING
operation does not indicate channel group, instead it indicates whether the unit is transmitting
or receiving. That's It!
Using the Intelion™ Battery System
The SkyBox™ Chroma features our proprietary Intelion™ Lithium-Ion internal battery system
which allows you the flexibility to operate your fixture without AC power for up to 20 hours.
To charge the battery, simply plug the fixture into a power source. The battery will charge weather
the fixture is powered on or off. It will even charge while in use! The built-
in microprocessor of the battery system controls the charge and overall
battery health, so all you need to do is plug and play.
The top section on the LCD display menu shows the battery power level
indicator displays the approximate amount of power remaining in the
battery. Each power level bar equals 20%. When charging, The CHARGE
status LED above the LCD display will illuminate in RED, then turn
when the charge is complete.
A full charge is obtained after charging for at least 4 hours. The fixture will automatically stop
charging when the battery is in optimal condition.
Power Output Mode:
Depending on the needs of any given application, you can select either High Power, Medium Power,
or Battery Saver Mode, which allows the fixture to run for a longer time at lower output.
a.) Press the <MENU> button until the display reads OUT MOD.
b.) Use the <UP/DOWN> buttons to select H (100%), M (75%) or S (50%).
c.) Press <ENTER> to confirm the setting.
Note: With average usage of color fades in High Output Mode, you can expect the battery life to
last up to 10+ hours, color jumping 5+ hrs, or full on for 3+ hrs. Display color/fade/chase/strobe,
and environmental factors including ambient temperature will all impact battery life.
SkyBox™ Chroma Manual Rev. A
RED
NOTE: "GROUP" number also
GREEN
corresponds to the "GROUP" setting
YELLOW
on our LightCaster™ wireless DMX
BLUE
transceiver, wiCICLE™ transmitter,
VIOLET
and all Blizzard Skywire™ wireless
CYAN
controllers.
RED
slowly until communication is established with the
GREEN
Page 9
slowly until communication
GREEN
© 2014 Blizzard Lighting, LLC
Advertisement
Table of Contents
