Step 3: Install Into Panel - HIS -ML23 Series User Manual

Step 3: Install into Panel

Once you have completed the full bench-test configuration and confirmed that all components are
working properly, you are ready to install the monitor into its panel cutout.
!
WARNING!
Hope Industrial Systems will not assume liability for damage to internal electronics
due to improper installation� Contact Hope Industrial Systems if you need additional
assistance�
1� Refer to the drawing below for the cutout dimensions for the HIS-ML23.
342.4 mm
(13.48")
2� Locate position in panel for mounting of the monitor. Ensure that there is adequate
space behind the panel. Allow extra space – 25.4 mm (1.0") behind and on each
side – for air ventilation.
566.7 mm
(22.31")
ML23B User Manual, October 2015
Installation Instructions
11