HIS -ML23 Series User Manual page 12

Installation Instructions
3� Cut a rectangular hole in the panel.
f Cutout Dimensions (W x H) for the HIS-ML23:
566.7 mm x 342.4 mm (22.31" x 13.48"); ± 0.5 mm (0.020")
4� Clean and deburr the panel hole�
5� Separate the rear collar from the monitor by removing the 14 nuts.
6� Refer to the enclosure mounting diagram below.
7� Insert the unit into the front of the panel and re-attach the collar�
NOTE: Contact Hope Industrial Systems if for any reason your application does
not allow for installation of the collar�
8� Tighten all 14 nuts to a torque of 10-15 inch-pounds to ensure a watertight seal
between the bezel gasket on the monitor and the equipment panel. Go around all
nuts twice to ensure an even compression on gasket.
NOTE: If a torque wrench is not available, tighten all nuts evenly until bezel sits
1�6 to 2�4 mm (1/16" to 3/32") off the front of the panel�
ML23B User Manual, October 2015
12