Step 3: Install Into Panel - HIS -ML19.5-A Series User Manual

Installation Instructions

Step 3: Install into Panel

Once you have completed the full bench-test configuration and confirmed that all components are
working properly, you are ready to install the monitor into its panel cutout.
! WARNING!
Hope Industrial Systems will not assume liability for damage to internal electronics
due to improper installation� Contact Hope Industrial Systems if you need additional
assistance�
1� Refer to the drawing below for the cutout dimensions for the HIS-ML19.5.
298.5 mm
(11.75")
2� Locate position in panel for mounting of the monitor. Ensure that there is adequate
space behind the panel� Allow extra space – 25�4 mm (1�0") behind and on each
side – for air ventilation�
12 ML19.5A User Manual, 99158B, September 2021
497.8 mm
(19.60")