Step 3: Install Into Panel - HIS -ML19 H Series User Manual

Installation Instructions

Step 3: Install into Panel

Once you have completed the full bench-test configuration and confirmed that all components are
working properly, you are ready to install the monitor into its panel cutout.
! WARNING!
Hope Industrial Systems will not assume liability for damage to internal electronics
due to improper installation� Contact Hope Industrial Systems if you need additional
assistance�
1� Refer to the drawing below for the cutout dimensions for the HIS-ML19.
366.8 mm
(14.44")
2� Locate position in panel for mounting of the monitor. Ensure that there is adequate
space behind the panel� Allow 12�7 mm (0�5") extra space behind and on each side
for air ventilation�
12 ML19H User Manual, 99154B, November 2022
453.4 mm
(17.85")