Link Handset To Telstra Gateway - Telstra T-VOICE502 User Manual

Link Handset to Telstra Gateway

Link your handset
1. On first use your T-Voice handset will prompt you to put the handset in registration mode. Press OK.
2. Long press the DECT button on your compatible Telstra gateway (T-Gateway/Telstra Gateway Max) for
5 seconds and release. The DECT light on the gateway will start flashing.
DECT
The DECT button is
located on either
the back or side of
your gateway.
3. If the handset keeps searching, repeat step 2.
4. When your handset is linked, you will now see the main handset screen. To start making and receiving calls
on your handset, ensure your gateway is wired correctly. Refer to "Wiring your Telstra gateway" located on
page 14 of this user manual.
12:01
PM
10 Mar
Phone 1
Contacts Menu
Your handset will look
similar to the diagram
above when it is ready.
Handset Range
The maximum range between the Telstra gateway and the Telstra T-Voice 502 handset is up-to 50 metres
indoors and 300 metres outdoors. Depending on the surrounding conditions as well as structural factors, the
range may be smaller. If the range is exceeded, the call will be disconnected unless you move back into range
within a few seconds.
• Do not expose the handset/charger to direct sunlight.
• Protect the handset/charger against moisture. Do not position the handset/charger in rooms exposed to
condensation, corrosive steam or excessive dust. Condensation can be present in basements, garages,
or sheds.
Position the handset/charger in a clean, dry and well-aired location. Choose a place which is stable, level,
and not subject to vibrations. To avoid mutual interference, do not position the handset/charger in the
immediate vicinity of electronic equipment such as hi-fi systems, office equipment or microwave ovens.
Avoid positioning the telephone near heat sources such as heating elements or near obstacles such as metal
doors, thick walls, and cupboards.
Telstra T-Gateway
DECT button
DECT
Telstra Gateway Max
DECT button
DECT
12