Husqvarna 305 Operator's Manual page 29

305_308,EN.book Page 29 Saturday, November 8, 2014 12:33 PM
Laying the boundary wire in towards the charging
station
The boundary wire must be laid in line with the rear
end of the charging station and at least 1.5 metres
straight out to the right and left of the station. See the
illustration. If the boundary wire is laid in any other
way, the robotic lawnmower may find it hard to find
the charging station.
Splicing the boundary wire
Use an original coupler if the boundary wire is not
long enough and needs to be spliced. It is waterproof
and gives a reliable electrical connection.
Insert both wire ends in the coupler. Check that the
wires are fully inserted into the coupler so that the
ends are visible through the transparent area on the
other side of the coupler. Now press down the button
on top of the coupler fully. Use a polygrip to
completely press down the button on the coupler.
IMPORTANT INFORMATION
Twinned cables, or a screw terminal block
that is insulated with insulation tape are not
satisfactory splices. Soil moisture will cause
the leads to oxidise and after a while result in
a broken circuit.
3. INSTALLATION
3018-072
3018-055
English - 29