Indicator Lamp In The Charging Station - Husqvarna 305 Operator's Manual

305_308,EN.book Page 69 Saturday, November 8, 2014 12:33 PM

9.2 Indicator lamp in the charging station

For a fully functional installation, the indicator lamp in the charging station must emit a solid green light.
If something else appears, follow the troubleshooting guide below.
There is more troubleshooting help on www.automower.com. If you still need help with troubleshooting,
please contact the local dealer.
Light
Solid green light
Green flashing light
Blue flashing light
Yellow flashing light
Red flashing light
Solid blue light
Solid red light
9. TROUBLESHOOTING
Cause
Everything in order
The signals are good and ECO mode
is activated.
The boundary wire is not connected
to the charging station
Break in the boundary wire.
The guide wire is not connected to
the charging station
Break in the guide wire
Interruption in the charging station's
antenna
Weak signal as the boundary wire is
too long.
Defective circuit board in the charging
station
Action
No action required
No action required. For more
information on ECO mode, see
6.6 Settings on page 54
Check that the boundary wire
connector is fitted properly to the
charging station. See 3.5 Connecting
the boundary wire on page 30.
Find out where the break is. Replace
the damaged section of the boundary
wire with a new loop wire and splice
using an original coupler.
Check that the guide wire connector
is properly connected to the charging
station. See 3.6 Installation of the
guide wire on page 31.
Find out where the break is. Replace
the damaged section of the guide
wire with a new loop wire and splice
using an original coupler.
Contact the local dealer.
No steps have to be taken if the
mower operates as expected.
Shorten the boundary wire by
reducing the working area or
replacing islands with barriers the
mower can collide with.
Contact the local dealer.
English - 69