Barco E-2320 C Service Manual page 41

Nio 2-3-5 MP
5. If necessary, wrap the power adapter in a plastic bag. Put the
adapter in the smallest compartment in the accessory box.
6. Be sure the connector cover is mounted on the display.
7. Push the display in the lowest position.
In case of a new type of foot, block its height positioning system
by means of the red fixation pin.
8. Put a foam block between the cable guidance wings on the foot.
Fix the foam block by means of adhesive tape.
9. Pull a plastic bag over the display.
10. Turn the display 90 degrees and put it in the proper foam buffer
piece.
Packaging instructions
41