Starting A New Job (Or Refilling The Cup); Reversible Tip Selection Chart - Graco 3A1698F Operation Manual

Starting a New Job (or Refilling the Cup)

Starting a New Job
(or Refilling the Cup)
When spraying flammable or combustible materials:
• Remove entire sprayer from hazardous location
when refilling.
• Always ground the material cup when refilling.
• Keep material containers covered between cup
refills.
1. Engage trigger lock and put prime/pressure relief valve
UP to release pressure.
ti16699a
ti14994a
2. Install material cup liner, fill with material, and
thread onto sprayer.
ti15474a
3. To prime pump, disengage trigger lock and trigger
sprayer for 10 seconds. Then release trigger and
put prime/relief valve DOWN to spray position.
ti16698a
ti14995a
3A1698F
ti16700a
ti14999a
ti16715a
ti16716a ti15425a
ti15418a
ti16701a
4. Reverse spray tip to UNCLOG position and spray
into waste area for five seconds.
ti14991a
ti14991a
5. Put prime/pressure relief valve UP to release pres-
sure. Then rotate tip back to spray position.
NOTE: Failure to perform this operation could result
in poor spray pattern.
ti16700a
NOTE: If sprayer fails to prime, follow Alternate
Priming Method (page 23).

Reversible Tip Selection Chart

Fine Finish Materials and Tip Sizes
Fan THIN
Width Stains
4 in.
208
(10 cm)
6 in.
308
(15 cm)
8 in.
(20 cm)
Use with all fine finish materials including "hot" solvents.
ti15491a ti14985a
ti16713a
MEDIUM HEAVY
Lacquers, Clears Enamels
210
310 312
410 412
ti16992a
13