Battery Disposal; Lifting The Vehicle - Ezgo RXV 646285 Owner's Manual

MAINTENANCE
Read all of SAFETY and this section before attempting any procedure. Pay particular attention to Notices, Cautions, Warnings and Dangers.

Battery Disposal

Return used batteries to the manufacturer or lead smelter for recycling purposes. For neutralized spills, put residue in
acid-resistant containers with absorbent material, sand or earth and discard according to state and federal regulations for
acid and lead compounds. Contact authorized environmental people for information about disposal.

LIFTING THE VEHICLE

You must lift the front, the rear or the entire vehicle for some service and maintenance operations.
Never get below a vehicle that is supported by a jack only.
Make sure a vehicle that is supported on jack stands is stable before you get below the vehicle.
Put wheel chocks in front and behind the wheels that remain on the ground.
When you lift the vehicle, put the jacks and jack stands at the areas indicated only.
Tool List
Floor Jack.................................................................... 1
Wheel Chocks ............................................................. 4
Remove payload from vehicle before lifting. No person(s) should be in or on the vehicle while lifting.
How to lift the entire vehicle:
1. Install wheel chocks in front and behind each front wheel.
2. Center the jack under the bagwell.
3. Lift the vehicle enough to place two jack stands under the frame where the leaf
spring mounting brackets are welded to the frame.
4. Lower the jack and test the stability of the vehicle on the two jack stands.
5. Place the jack under the center front just behind the bumper.
6. Lift the vehicle and place two jack stands under the frame where the instrument
panel support is attached to the frame.
7. Lower the jack and test the stability of the vehicle on the jack stands.
How to lift the rear of the vehicle only:
1. Install wheel chocks in front and behind each rear wheel.
2. Center the jack under the bagwell.
3. Lift the vehicle enough to place two jack stands under the frame where the leaf spring mounting brackets are welded
to the frame.
4. Lower the jack and test the stability of the vehicle on the jack stands.
38
The vehicle is not stable during the lifting process.
Make sure the vehicle is on a hard and level surface.
Do not allow any person in or on the vehicle being lifted.
Quantity Tool List
Jack Stands................................................................. 4
Owner's Guide
Quantity