Form Set-Up Procedure With Tractor & Slitters - Formax FD 540 Operator's Manual

SET-UP PROCEDURES FOR
MODELS WITH SLITTERS
FOLLOW FORM SET-UP PROCEDURES 1 THRU 9 AND
PROCEED AS FOLLOWS.
1. Noting the Blade Indicator Marks on the Upper Guide table so
the Edge Slitters, position each Edge Slitter in from of the corner
edges of the form to trim edges as desired. (Fig. 13)
2. Lock the Edge Slitters in place by tightening the Thumb screws
clockwise.
3. While rotating the Burster Handwheel clockwise,
slowly push the form through the Edge Slitters.
NOTE: To thread paper you do not wish to slit, push the Edge
Slitters apart and out of the way. To use Center Slitter, position
Slitters where cut is desired, tighten thumbscrew and set
screws.
4. Continue with steps 10 thru 11 in the Forms Set-Up
Procedures Section.
SET-UP PROCEDURES FOR
MODELS WITH SLITTERS AND
TRACTORS
FOLLOW FORM SET-UP PROCEDURES 1 THRU 8 AND
PROCEED AND FOLLOWS.
1. Unlock Tractors and open Tractor Gates.
2. Place the form on the Feed Pins. (Fig, 14)
NOTE: Do not stretch the form too tightly between
the pins; the pins should be entered in the margin holes.
3. Close Tractor Gates and lock by pushing the lever forward
4. Continue with steps 9 through 11 in the Forms Set-up
Procedures section.
9