Table of Contents
Advertisement
SYMPTOM
Large variation in trim accuracy.
Form pull out to tractors.
Uneven Inking.
Uneven Signature Position.
Incorrect Counting.
Upper/Lower Side Guides too loose/tight.
Paper pack not centered to Slitter
Infeed. Brush Tension to tight.
Incorrect Burster roller timing.
Incorrect Tear Bar setting.
Insufficient Feed roller tension.
Ink Roll not adjusted uniformly.
Ink Roll dried up, or not turning freely.
Signature patch worn or installed improperly.
Forms not in Tractors.
Print Cylinder timing incorrect.
Incorrect form size,
Signature patch position(s) incorrect.
Check roller timing-imprint position.
Set infeed tension higher.
Clean rollers.
Code Mode Switch in wrong position.
Counter not cleared to zero.
14
PROBABLE CAUSE
Advertisement
Table of Contents
