Barco RLM W8 Service Manual page 42

2-7. Click "Search" button, the available COM port (likes COM:1) will be listed after searching
and shown as follows
2-8. Click on the available COM port (e.g. COM: 1 in this example) and select the target
firmware (Image File) by clicking the "Browse ..." button.
2-9. After selecting the firmware file, press the "Update Firmware" to start the firmware
upgrade process.
2-10. The firmware upgrade status will be shown on the status bar of the firmware updater to
indicate the progress of this firmware download.
2-11. After finishing the firmware download, please recycle the AC switch to finish the overall
firmware download process of sxW2.
3. Firmware downloads procedure for RJ-45 module:
3-1. Connect the AC power of the projector and have the projector in standby mode.
3-2. Connect the RJ-45 cable between the projector and the PC. And make sure that the two
LEDs of the RJ-45 module are lit after connecting the RJ-45 cable between the PC and the
projector. If the LEDs are not lit, please send the RS command "eco.net.pow = 0" on the
terminal to turn on the RJ-45 module.
3-3. Properly setup the IP for the PC and make sure that the PC and the projector are in the
same subnet. For example, the default IP of the projector is 192.168.0.100. So the IP of the
PC should be set as 192.168.0.99 for example.
- 42 -