Sony PDW-HD1550 Operation Manual page 107

Item
M49: RESET ALL SETUP
Item
M50: DHCP
M51: IP ADDRESS
M52: SUBNET MASK
M53: DEFAULT GATEWAY
M54: LINK SPEED
a)
M56: JUMBO FRAME
M5A: NetBIOS
M5F: RESET NET CONFIG
M4: SETUP MAINTENANCE: Items relating to the setup menu
Setting
Reset all the menu settings to the factory settings.
Push the SAVE function button (F5): Reset.
Push the MENU button: Return to the next highest menu level without resetting.
Notes
• The system frequency setting is also cleared. If you execute this item, reset the
system frequency (see page 34).
• Date and time settings are not cleared, but the time zone setting is cleared.
After executing this item, reset the time zone (see page 106).
M5: NETWORK: Items relating to network settings
Setting
Set whether to assign an IP address automatically with the DHCP server.
DISABLE [dis]: Do not assign automatically.
ENABLE [ena]: Assign automatically.
Set the IP address of this unit.
192.168.001.010
Notes
• IP address cannot be set when DHCP is set to "ENABLE".
• To check the automatically acquired IP address of this unit, close the maintenance
menu and then open it again.
Set the subnet mask.
255.255.255.000
Notes
• Subnet mask cannot be set when DHCP is set to "ENABLE".
• To check the automatically acquired subnet mask, close the maintenance menu
and then open it again.
Set the address of the default gateway.
000.000.000.000
Notes
• The address of the default gateway cannot be set when DHCP is set to "ENABLE".
• To check the automatically acquired address of the default gateway, close the
maintenance menu and then open it again.
Set the communications speed and protocol.
AUTO [auto]: Sets automatically.
1Gbps FullDuplex [1G F]: 1 Gbps, full duplex
100Mbps FullDuplex [100 F]: 100 Mbps, full duplex
100Mbps HalfDuplex [100 H]: 100 Mbps, half duplex
10Mbps FullDuplex [10 F]: 10 Mbps, full duplex
10Mbps HalfDuplex [10 H]: 10 Mbps, half duplex
Set the size of jumbo frames.
9014, 4088, OFF
Note
This value does not include the 4 bytes of the FCS (Frame Check Sequence).
Specify whether to enable NetBIOS over TCP/IP.
off: Disable.
on: Enable.
Reset network settings to the factory defaults.
Push the SAVE function button (F5): Reset.
Push the MENU button: Return to the next highest menu level without executing the
reset.
107
Maintenance Menu