Sony PDW-HD1550 Operation Manual page 94

Item number Item name
201 PARA RUN
214 REMOTE INTERFACE
257 NETWORK ENABLE
259 NETWORK INTERFACE
Item number Item name
320 DIGITAL AUDIO PB PROCESS ON
EDIT POINT
Item number Item name
501 STILL TIMER
94
Setup Menu
Menu items in the 200s, relating to the remote control interface
Settings
Select whether to use synchronized operation, when you have
connected two or more PDW-HD1550 units in a daisy chain or
distributed configuration, and are using external control from a VTR or a
remote controller such as the RM-280.
disable [dis]: No synchronized operation
enable [ena]: Use synchronized operation
Notes
• If you are controlling from a VTR, select "enable" on all of the
PDW-HD1550 units.
• If you controlling from the RM-280 or another remote control device,
select "disable" on one of the PDW-HD1550 units and select "enable"
on all of the other PDW-HD1550 units.
When the remote control switch is set to REMOTE, select the device
from which to remote-control this unit.
9PIN: Device connected to the REMOTE (9P) connector.
SDI: Device connected to the SD/HDSDI INPUT connector.
Select the remote control switch positions which enable network
connections.
network [net]: Only when the remote control switch is set to "NET".
network & remote(9PIN) [n&9P]: When the remote control switch is
Select network protocols to be enabled.
FTP/CIFS [ftp]: Enable FTP and CIFS.
NET-RMT [nrmt]: Enable NetAPI and WebAPI.
ALL [all]: Enable all protocols.
Menu items in the 300s, relating to editing operations
Settings
Specify the handling of audio at edit points.
cut: Carry out a cut (possibly resulting in audio discontinuities at the edit
point).
fade: Fade out and fade in.
Menu items in the 500s, relating to disc protection
Settings
To protect the disc against shock and vibration, and to lengthen the life of
the laser diodes, the unit automatically enters standby state whenever a
specified time elapses in a disc stop mode (stop mode or the still picture
mode of search mode). This allows you to set the time after which the unit
exits the disc stop mode and enters standby state.
0.5 sec [0.5 s]... 8 min [8 m]... 30 min [30 m]: Can be set in the range
from 0.5 seconds to 30 minutes.
off: Do not put into standby state.
set to "NET", or when the switch is set to "REMOTE" and setup
menu item 214 is set to "9PIN".