Auto Calibration - Datalogic Matrix 300N Reference Manual

SOFTWARE CONFIGURATION
7
Restore Factory Defaults
In order to return a device to its absolute Factory default parameters (for example device
replacement) it is necessary to use the Restore Factory Defaults command. You will be
prompted to confirm.
All Environment parameters will be restored to Factory default values and any existing
configurations stored on the device will be erased. The device will be reset and therefore
start in run mode with the factory default configuration.

7.2.3 Auto Calibration

DL.CODE provides the Image Auto-Setup tool to maximize the reading performance by
tuning the acquisition parameters (photometry) automatically. By selecting the Image Auto-
Setup tool from the Image Setup step, the following window appears:
Figure 69 – Image Auto-Setup
Select the Static or Dynamic Self-Tuning option; Start Autolearn and Apply to the Image
Setup. The Image Setup window works interactively so that you can see the results of the
parameter setting changes as well as the decoding results (Results panel). When switching
to the Code Setup step you can also see the decoding results displayed on the image.
Figure 70 – Decoding Results OK
131