Ide Device Drivers - DFI G586IPV User Manual

DISPLAY SWITCH IS SET INCORRECTLY
The display switch on the motherboard can be set to either mono-
chrome or color. This indicates the switch is set to a different setting
than indicated in Setup. Determine which setting is correct, then either
turn off the system and change the jumper or enter Setup and change
the VIDEO selection.
FLOPPY DISK(S) fail (80) → Unable to reset floppy subsystem.
FLOPPY DISK(S) fail (40) → Floppy type mismatch.
Hard Disk(s) fail (80) →
Hard Disk(s) fail (40) →
Hard Disk(s) fail (20) →
Hard Disk(s) fail (10) →
Hard Disk(s) fail (08) →
Keyboard is locked out - Unlock the key
The BIOS detects that the keyboard is locked. Keyboard controller is
pulled low.
Keyboard error or no keyboard present
Cannot initialize the keyboard. Make sure the keyboard is attached cor-
rectly and no keys are being pressed during the boot.
Manufacturing POST loop
System will repeat POST procedure infinitely while the keyboard con-
troller is pull low. This is also used for M/B burn in test at the factory.
BIOS ROM checksum error - System halted
The checksum of ROM address F0000H-FFFFFH is bad.
Memory test fail
BIOS reports memory test fail if the memory has error(s).

IDE Device Drivers

To install the IDE drivers supported by the G586IPV/E system board,
please refer to the " Readme" file contained in the provided diskettes.
HDD reset failed.
HDD controller diagnostics failed.
HDD initialization error.
Unable to recalibrate fixed disk.
Sector Verify failed.
43