Back Panel
Reset
Button
Reset
Detail
Ground
Power
Description
There are two methods to reset the
EdgeRouter X to factory defaults:
Runtime Reset (Recommended)
The EdgeRouter X should be running after
bootup is complete. Press and hold the Reset
button for about 10 seconds until the eth4
LED starts flashing and then becomes solidly
lit. After a few seconds, the LED will turn off,
and the EdgeRouter X will automatically
reboot.
Power‑on Reset
1. Disconnect the Power Adapter from the
EdgeRouter X.
2. Press and hold the Reset button while
connecting the Power Adapter to the
EdgeRouter X. Keep holding the button
until the eth4 LED starts flashing and then
stops flashing after a few seconds.
Description
ESD grounding for enhanced ESD protection.
The ground wire and screw with washer
are not included (recommended screw size:
M3-0.5 x 4 mm).
Connect the Power Adapter.
Ground
Power