Table of Contents
Advertisement
4.2
Cleaning
4.3
Replacing
Keypad
Batteries
placed near or over a radiator or heat register. The projector should not be placed
in an enclosure unless proper ventilation is provided.
Do not push objects of any kind into the projector through the ventilation
openings. They may touch dangerous voltages or short-out components resulting
in a fire or shock hazard. Do not spill liquids of any kind into the projector.
Should an accidental spill occur, immediately unplug the projector and have it
serviced by a qualified service technician.
If any of the following conditions exist, unplug the projector from the power
outlet and refer service to qualified service personnel.
•
The power cord has been damaged.
•
The internal cooling fans do not come on when the projector is first turned on.
•
Liquid has been spilled into the projector.
•
The projector has been exposed to excessive moisture.
•
The projector does not operate normally.
•
The projector has been dropped or the case has been damaged.
•
Projector performance has deteriorated.
Do not attempt to service the projector yourself. All servicing must be performed
by a qualified Electrohome service technician. If replacement parts are required,
it is important that only Electrohome-approved parts are used. Other parts may
result in fire, electric shock or risk of personal injury.
Clean the projector when required. Before cleaning, always unplug the projector
from the power outlet.
To avoid the risk of scratching the lens, only clean the lens if absolutely
required. A small amount of dust on the lens will have very little effect on
picture quality. If the lens must be cleaned, use a DRY soft cotton cloth. Rub
gently in a circular motion.
It is important to never touch the sapphire (glass) surface of the lamp, as the oil
imprint will seriously degrade lamp performance. However, should you
accidentally touch the surface of the lamp, clean gently with a lint-free cloth
moistened with isopropyl alcohol.
Clean the case with a soft dampened cloth. Use a mild commercial cleaner. Do
not use liquid or aerosol cleaners.
The IR Remote Keypad uses four AA size, 1.5V batteries (preferably aklaline).
To install new batteries, open the battery compartment at the back side of the
keypad by pulling on the raised portion of the cover as shown (Figure 4.1)
Remove the old batteries and properly discard. Place the new batteries in the
compartment, orienting the positive/negative of each battery according to the
labels in the compartment. When batteries are in place, replace the cover by
inserting its bottom edge first and snapping the top into place. Do not force.
MAINTENANCE
8EIJ=/4)20: #
User's Manual
4-3
Advertisement
Table of Contents
