OSEE RMD7023 User Manual page 22

Image Video devices on the same serial bus. Each name can be up to 16 ASCII characters.
Press ENTER to edit the UMD. Use the ENTER button to move the cursor. Press ENTER with the
cursor on the character to be changed and use the Up/Down button to scroll through character
options. Press ENTER to choose a character. Press MENU to return to the up menu and save the
UMD setting.
*9. UMD TLY Mode
Use this setting when using Image Video tally control. Choose one of the following settings, in
conjunction with the Image Video controlling device. T1, T2, T1T2, T2T1, T1-, T2-, T1T2-, T2T1-.
Consult Image Video documentation for further information.
*10. UMD Baud Rate
Use this setting to choose the baud rate. The baud rate must be set in conjunction with the
controlling device. Available baud rates are 2400, 4800, 9600, 19200, 38400, 57600, 115200.
*11. Tally Source
The unit tally (OSD and LED) can be controlled in a variety of different ways. Use the Tally
Source setting to choose how tally is controlled:

Standard
Use the Standard setting to control tally via contact closure on the DB-9 tally interface.

Image Video HW
Use the Image Video HW setting to control Image Video tally states via contact closure
on the DB-9 tally interface. Contact closure of the Red pin corresponds to Image Video
Tally 1, and the Green pin maps to Image Video Tally 2. Contact closure (ground)
corresponds to a LOW state, and open circuit corresponds to a HIGH state. This mode
requires the UMD Tally Mode parameter to be set. Consult Image Video documentation
for further information.

Image Video 422
Use the Image Video 422 setting to control Image Video tally states via the Image Video
serial protocol. This mode requires the UMD Tally Mode parameter to be set. Consult
Image Video documentation for further information.

Standard + IV422
Use the Image Video 422 setting to control Image Video tally states via the Image Video
serial protocol, while controlling LED and OSD tally using contact closure on the DB-9
tally interface. This mode requires the UMD Tally Mode parameter to be set. Consult
Image Video documentation for further information.

TSL
Use the TSL setting to control OSD and LED tally via the TSL protocol.
—18—
RMD7023 LCD MONITOR User Manual