High/Low Beam Switch; Windshield Wipers And Washers; Windshield Wiper Operation - Jeep 2011 WK2 Grand Cherokee Owner's Manual

High/Low Beam Switch

Push the multifunction lever toward the instru-
ment panel to switch the headlights to high
beam. Pulling the multifunction back toward the
steering wheel will turn the low beams back on,
or shut the high beams off.
WINDSHIELD WIPERS AND
WASHERS
The windshield wiper/washer control lever is
located on the left side of the steering column.
The front wipers are operated by rotating a
switch, located on the end of the lever. For
information on the rear wiper/washer, refer to
"Rear Window Features" in "Understanding the
Features of Your Vehicle".
110
Windshield Wiper/Washer Switch

Windshield Wiper Operation

Rotate the end of the lever to one of the first four
detent positions for intermittent settings, the
fifth detent for low wiper operation and the sixth
detent for high wiper operation.
Windshield Wiper Operation
CAUTION!
Always remove any buildup of snow that
prevents the windshield wiper blades from
returning to the "park" position. If the wind-
shield wiper switch is turned off, and the
blades cannot return to the "park" position,
damage to the wiper motor may occur.