Jeep 2011 WK2 Grand Cherokee Owner's Manual page 82

NOTE:
• The default number is 112. The number
dialed may not be applicable with the
available mobile service and area.
• If supported, this number may be pro-
grammable on some systems. To do this,
press the button and say "Setup",
followed by "Emergency".
• The Uconnect™ Phone does slightly
lower your chances of successfully mak-
ing a phone call as to that for the mobile
phone directly.
WARNING!
To use your Uconnect™ Phone System in an
emergency, your mobile phone must be:
• turned on,
• paired to the Uconnect™ System,
• and have network coverage.
Breakdown Service — If Equipped
If you need Breakdown service:
• Press the
button to begin.
• After the Ready prompt and the following
beep, say "Breakdown service".
80
NOTE:
The Breakdown service number has to be
setup before using. To setup, press the
button and say "Setup, Breakdown Service"
and follow prompts.
Paging
To learn how to page refer to "Working with
Automated Systems". Paging works properly
except for pagers of certain companies which
time out a little too soon to work properly with
the Uconnect™ Phone.
Voice Mail Calling
To learn how to access your voice mail, refer to
"Working with Automated Systems".
Working With Automated Systems
This method is used in instances where one
generally has to press numbers on the mobile
phone keypad while navigating through an
automated telephone system.
You can use your Uconnect™ Phone to access a
voice mail system or an automated service, such
as a paging service or automated customer
service. Some services require immediate re-
sponse selection. In some instances, that may
be too quick for use of the Uconnect™ Phone.
When calling a number with your Uconnect™
Phone that normally requires you to enter in a
touch-tone sequence on your mobile phone
keypad, you can press the
say the sequence you wish to enter followed by
the word "Send". For example, if required to
enter your PIN followed with a pound, (3 7 4 6
#), you can press the
7 4 6 # Send". Saying a number, or sequence of
numbers, followed by "Send", is also to be
used for navigating through an automated cus-
tomer service center menu structure, and to
leave a number on a pager.
You can also send stored Uconnect™ Phone-
book entries as tones for fast and easy access
to voice mail and pager entries. To use this
feature, dial the number you wish to call and
then press the button and say "Send."
The system will prompt you to enter the name or
number and say the name of the phonebook
entry you wish to send. The Uconnect™ Phone
will then send the corresponding phone num-
ber associated with the phonebook entry, as
tones over the phone.
button and
button and say, "3