To Open And Close The Hood; Easy Entry/Exit Seat - Jeep 2011 WK2 Grand Cherokee Owner's Manual

NOTE:
Once programmed, all RKE transmitters
linked to memory can be easily enabled or
disabled at one time. Refer to "Electronic
Vehicle Information Center (EVIC)/Customer -
Programmable Features" in "Understanding
Your Instrument Panel" for further informa-
tion.

Easy Entry/Exit Seat

This feature provides automatic driver's seat
positioning which will enhance driver mobility
out of and into the vehicle.
There are two possible Easy Exit and Easy
Entry adjustments available:
• The seat cushion will move rearward ap-
proximately 2 in (60 mm) if the starting
position of the seat is greater than or equal to
2.5 in (68 mm) forward of the rear seat stop
when the key is removed from the ignition
switch. The seat will then move forward
approximately 2 in (60 mm) when the key is
placed into the ignition and turned out of the
LOCK position.
• The seat shall move to the position located
0.3 in (8 mm) forward of the rear stop if the
starting position is between 1 in to 2.5 in (23
to 68 mm) forward of the rear stop when the
key is removed from the ignition switch. The
seat will move forward to the memory/driving
position when the key is placed into the
ignition, and turned out of the LOCK position
toward the RUN position.
The Easy Entry/Easy Exit feature will be auto-
matically disabled if the seat is already posi-
tioned closer than 1 in (23 mm) forward of the
rear stop. At this position, there is no benefit to
the driver by moving the seat for Easy Exit or
Easy Entry.
Each stored memory setting will have an asso-
ciated Easy Entry and Easy Exit position.
NOTE:
The Easy Entry Easy Exit feature is not
enabled when the vehicle is delivered from
the factory. The Easy Entry Easy Exit feature
is enabled (or later disabled) through the
programmable features in the Electronic Ve-
hicle Information Center (EVIC). Refer to
"Electronic Vehicle Information
(EVIC)/Customer-Programmable Features"
in "Understanding Your Instrument Panel"
for further information.

TO OPEN AND CLOSE THE HOOD

1. To open the hood, pull the release lever,
located below the instrument panel on the
driver-side of the vehicle.
Hood Release Lever
Center
103