Shifting Procedures - Jeep 2011 WK2 Grand Cherokee Owner's Manual

NOTE:
Refer to "Selec-Terrain – If Equipped" in
"Starting and Operating" for further infor-
mation on the various positions and their
intended usages.
NEUTRAL
This range disengages both the front and rear
driveshafts from the powertrain. It is to be used
for flat towing behind another vehicle. Refer to
"Recreational Towing" in "Starting and Operat-
ing" for further information.
4WD LOW
This range is for low speed four-wheel drive. It
locks the front and rear driveshafts together
and forces the front and rear wheels to rotate at
the same speed. It provides additional traction
and maximum pulling power for loose, slippery
road surfaces only. Do not exceed 25 mph
(40 km/h).
NOTE:
Refer to "Selec-Terrain – If Equipped" for
further information on the various positions
and their intended usages.

Shifting Procedures

4WD HI to 4WD LOW
With the vehicle at speeds of 0 to 3 mph (0 to
5 km/h), the ignition switch in the ON position or
the engine running, shift the transmission into
NEUTRAL, and press the "4WD LOW" button
once on the transfer case switch. The "4WD
LOW" indicator light in the instrument cluster
will begin to flash and remain on solid when the
shift is complete.
Transfer Case Switch
NOTE:
If shift conditions/interlocks are not met, or
a transfer case motor temperature protec-
tion condition exists, a "For 4x4 Low Slow
Below 3 MPH or 5 KPH Put Trans in N Press
4 Low" message will flash from the Elec-
tronic Vehicle Information Center (EVIC). Re-
fer to "Electronic Vehicle Information Center
(EVIC)" in "Understanding Your Instrument
Panel" for further information.
4WD LOW to 4WD HI
With the vehicle at speeds of 0 to 3 mph (0 to
5 km/h), the ignition switch in the ON position or
the engine running, shift the transmission into
NEUTRAL, and press the "4WD LOW" button
once on the transfer case switch. The "4WD
LOW" indicator light in the instrument cluster
will flash and go out when the shift is complete.
NOTE:
• If shift conditions/interlocks are not met,
or a transfer case motor temperature pro-
tection condition exists, a "For 4x4 High
Slow Below 3 MPH or 5 KPH Put Trans in
N Press 4 Low" message will flash from
the Electronic Vehicle Information Center
209