Driver Memory Seat — If Equipped - Jeep 2011 WK2 Grand Cherokee Owner's Manual

Reclining Rear Seat
To recline the seatback, lift the lever located on
the outboard side of the seat, lean back and
release the lever at the desired position. To
return the seatback, lift the lever, lean forward
and release the lever.
WARNING!
Do not ride with the seatback reclined so that
the shoulder belt is no longer resting against
your chest. In a collision you could slide under
the seat belt, which could result in serious
injury or death.
DRIVER MEMORY SEAT —
IF EQUIPPED
Once programmed, the memory buttons 1 and
2 on the driver's door panel can be used to
recall the driver's seat, driver's outside mirror,
and radio station preset settings. Your Remote
Keyless Entry (RKE) transmitters can also be
programmed to recall the same positions when
the UNLOCK button is pressed.
Driver Memory Switches
Your vehicle is delivered with two RKE transmit-
ters. One or both RKE transmitters can be
linked to either memory position. The memory
system can accommodate up to four RKE
transmitters, each one linked to either of the
two memory positions.
Setting Memory Positions and
Linking Remote Keyless Entry
Transmitter to Memory
NOTE:
Each time the SET (S) button and a num-
bered button (1 or 2) are pressed, you erase
the memory settings for that button and
store a new one.
1. Insert the ignition key and turn the ignition
switch to the ON position.
2. Press the driver's door MEMORY button
number 1 if you are setting the memory for
driver 1, or button number 2 if you are setting
the memory for driver 2. The system will recall
any stored settings. Wait for the system to
complete the memory recall before continuing
to Step 3.
3. Adjust the driver's seat, recliner, and driver's
sideview mirror to the desired positions.
4. Turn on the radio and set the radio station
presets (up to 12 AM and 12 FM stations can
be set).
101