Electrical Characteristics; Interface Signals 3.2 Interface - Philips 170C5 Service Manual

46
Go to cover page
3.0

Electrical characteristics

3.1 Interface signals
The input signals can be applied in below modes:
1). D-shell Analog
Input signal: Video, H-sync, V-sync,
Video: 0.7 V p-p, input impedance, 75 ohm
Sync. : Separate sync TTL level, input impedance 2k2 ohm terminate
3.2 Interface
3.2.1 D-Sub Cable
Length
Connector type
Pin Assignment:
17 inch LCD Monitor
TYPE
BRAND : PHILIPS
2004-06-08
Jerry Chen/Peter V
H-sync Positive/Negative
V-sync Positive/Negative
Composite sync TTL level, input impedance 2k2 ohm
terminate
Sync on green video 0.3V p-p Negative. (Video 0.7 V p-p
Positive)
: 1.8 M +/- 50 mm (fixed)
: D-sub male with DDC-2B pin assignments.
Blue connector thumb-operated jack screws
PIN No. SIGNAL
1 Red video input
2 Green video input / sync on green
3 Blue video input
4 GND
5 GND- Cable detect
6 Red video GND
7 Green video GND
8 Blue video GND
9 DDC +3.3V or +5V
10 Logic GND
11 GND
12 Serial data line (SDA)
13 H-sync / H+V
14 V-sync
15 Data clock line (SCL)
: 170C5BS/00
2004-06-08
"
(Positive/Negative)
"
"
8639 000 15502
7
590
26