Vermont Castings VCT323SSN/P Assembly Procedures page 12

VCT323SSN/P Assembly
Step 13: Install the Ignitor Battery
Figure 13
Unscrew the ignition button from the console and insert a 'AAA' battery into the housing.
Then screw the ignition button back into the console.
Check for sparks under each main burner before proceeding.
Step 14: Install Battery Holder and Backlighting Battery
Parts Required:
(1) Battery Holder
(1) #10-24 x 1/2" Screws (50000337)
(1) #10-24 Lock Nut (50000182)
Figure 14
NOTE: A 9-volt battery is required (not included).
Assemble as shown and tighten fasteners.
Attach back-light wire connector to battery. Install in battery
holder with back-light connector on top.
WARNING: Replacing the battery incorrectly might result in
an explosion. Replace the battery only with the same
or equivalent type recommended by the manufacturer.
Dispose of used batteries according to your local envi-
ronmental guidelines.
Figure 14a
B479
CAUTION: Some parts may have sharp edges; to avoid injury, wearing gloves during assembly, lifting or moving
the grill is recommended. B479
12
battery holder
Figure 13
Figure 14
Battery
Battery Holder
-
+
B474
B474
install battery
B478
B478
battery holder
Ignition Button
Battery Holder
30006291