Travis Industries 564 DF GSR2 Installation Manual page 58

58 Finalizing the Installation
4 Remove the burner by lifting it up slightly and sliding it to the right.
5 Follow the directions below to replace the orifices.
© Travis Industries
Orifice
Use a 1/2" open end wrench
b
to unscrew the orifice.
1/2" Wrench
d
Screw each LP orifice in so the
orifice protrudes 15/16" (24mm)
(indicating full insertion).
Orifice Size
(for qualified installers only)
Rotate the air shutter away
from the orifice and slide it out
a
to gain access to the orifice.
c
Apply thread sealant to the LP
orifice prior to installation. Use
the chart below to identify the
correct orifice.
Look here for the orifice identification
15/16"
24mm
NG LP
#46 DMS 1.3mm
4140926 100-01395