Parent Unit Power Supply - Motorola MBP43 User Manual

2.3

Parent Unit Power Supply

IMPORTANT
Installing the rechargeable battery pack and charging it fully before use is
recommended. This will allow the unit to operate on battery in the event
of a power failure.
1. Connect the small plug of the power adapter to the parent unit and
the other end to the electrical outlet. Only use the enclosed power
adapter (6V DC/500mA).
2. Press and hold the
turn ON the parent unit.
3. Once the baby and parent units are switched on, the display on the
parent unit will show the video captured by the baby unit.
4. If there is no connection or you are out of range, the video display
will go off and the icon
unit will beep every 5 seconds. Move the parent unit closer to the
baby unit until the link is re-established.
5. Press and hold the
bar finishes scrolling, to turn OFF the parent unit.
NOTE
The battery icon
needs to be recharged. The battery pack takes about 16 hours to charge
fully.
When charging
1. If the parent unit is turned OFF, when the adapter is plugged in, a
mains plug logo will display briefly, followed by a large battery icon
with internal segments cycling for 45 seconds. The Blue LED in the
top left corner lights up to indicate the adapter is plugged in.
Getting Started
P
POWER ON/OFF button for 1 second to
will be shown on the LCD display, and the
P
POWER ON/OFF button, until the progress
turns RED to indicate that the battery is low, and it
9