Motorola MBP48 Troubleshooting Manual

FAQ
Troubleshooting
Topic What can I do if my screen is blank?
Related Products Motorola MBP48, MBP48-2
No display
• Try recharging or replacing the battery pack.
• Reset the units. Disconnect the battery pack of the parent unit and unplug both the units'
electrical power, then plug them back in.
• Is the unit turned on? Press and hold the POWER ON/OFF button P on the parent unit to turn
it ON.
• Is the correct camera selected? Change the camera number, if necessary.
• Is the video display turned on? Press the VIDEO ON/OFF button V to turn it on.
• When operating using batteries only, the Display will go blank after 5, 30 or 60 minutes to
save power (depending on video on setting). The unit is still active and will give you audio
alerts. You can reactivate the screen by pressing any button.
Low battery light on the parent unit screen flashes
Related Products Motorola MBP48, MBP48-2
• Battery pack in the parent unit is running low. Connect the parent unit to the main power
with the supplied power adaptor for recharging.
Why is the Talk Back feature not working?
Related Products Motorola MBP48, MBP48-2
1. Increase the volume on the parent unit.
2. Check that you have released the button after speaking to hear the response. The button is
pressed only when you are speaking.
3. The parent and baby unit may be out of range. Reduce the distance between the two.
4. Verify that the connections on the baby unit and at the electrical outlet are secure.
5. Lift the antenna on the parent unit for optimal reception.
Why is the Parent Unit beeping?
Related Products Motorola MBP48, MBP48-2
1. The power switch on the baby unit is set to OFF. Switch it ON.
2. Check that the beep is not a result of setting the alarm . Select OFF in the alarm menu.