Hangar 9 Twist 60 ARF Assembly Manual page 10

Section 1: Aileron Servo Installation
 
. .Step 7
Secure.the.servo.using.the.screws.provided.with.the.
servo..Remove.the.stock.servo.horn.and.install.a.long.
servo.arm.in.its.place..Remove.the.side.of.the.arm.that.
does.not.align.with.the.control.horn.
 
. .Step 8
Enlarge.the.outer.hole.of.the.servo.arm.using.a.5/64".
(2mm).drill.bit..Remove.the.pushrod.keeper.from.the.
linkage.and.slide.the.bend.to.the.servo.arm..Secure.the.
pushrod.to.the.servo.arm.by.replacing.the.pushrod.keeper.
10
 
. .Step 9
Attach.the.clevis.to.the.control.horn..With.the.radio.system.
on.and.the.aileron.trim.and.stick.centered,.check.that.the.
aileron.is.centered.when.viewed.from.the.wing.tip..Adjust.
the.length.of.the.linkage.if.necessary.
 
. .Step 10
Use.tape.on.the.servo.lead.to.prefvent.it.from.falling.back.
into.the.wing.

.Step 11
Repeat.Steps.1.through.10.for.the.remaining.aileron.servo.