Table of Contents
Advertisement
Reset to the Factory Default Setting
After you've check through the above steps, you should be able to use
the iWizard to scan for the camera which you've just installed. If none
of the above worked, please reset the camera and follow the above
procedures again.
Once the camera had been reset, please give it 2 minutes to reboot
and start the iWizard to scan for the camera.
Firmware Update
You can download the latest firmware from Compro's website.
(www.comprousa.com)
After download the file, please go the web interface of IP camera
control, and select the download file to update your firmware.
2.
30
You can reset the camera to the default state
where it will use the onboard LAN connection and
get IP from the available local DHCP server. To
reset the camera, please power on the camera
for 2minutes then press and hold the reset
button on the back of the camera for 10 seconds
in order to reset setting to factory default.
3.
1.
Advertisement
Table of Contents
